Professional Design Klinger Reflex Glass - Qls Water-Absorbing Breather Filter – Xinyuan

Water pollution in hydraulic oil is more harmful than solid particles, and water intrusion is mainly through the tank vent.

The fluid level in the tank will change at any time when the hydraulic system is working. When drawdown, moist air will enter the tank, the percentage of water vapor in the air directly dissolves in the oil, the part of the water vapour met cool we di and condensed water drop into the oil tank wall, this type of moisture absorption air temperature device specially designed for the above situation, which can effectively prevent the water into the tank, favorable to improve the working performance and reliability of the hydraulic system.

QLS water-absorbing breather filter can prevent water from getting into the tank. It has transparent filter. bowl, so it is clear enough to see the hygroscopic agent change. It is with sealed structure.

1. transparent shell, so that the hygroscopic agent state change caused by color change at a glance.

2. Closed structure, directly discharge the air into the atmosphere without passing through the hygroscopic device, prolong the service life of the hygroscopic agent.

3. the cost is low, and the hygroscopic agent can be reused after drying and reduce maintenance costs.

The air flow：1 m7min

Air leakage accuracy：wi80um

Suction pressure：0.03MPa

Expiratory pressure：0.02MPa

Amount of moisture absorption：IKg

QLS 1 -1 -10
Design a sequence number

Amount of moisture absorption：1kg
Hygroscopic air dripper

The working principle of this type of hygroscopic air temperature cleaner is shown in the figure. The dry hygroscopic agent is blue, and after hygroscopic the color becomes pale and gradually turns red until it becomes reddish. When the hygroscopic agent is pink, hygroscopic agent is nearly saturated, should be replaced or dried.

When replacing, you can hold the lower part of the hygroscopic device to loosen and unload the bottom plate, and then screw down four cover screw spots, you can open the top cover to replace the hygroscopic agent.

Hygroscopic agent can be placed in the oven about 150 to dry, hygroscopic agent is blue can be used again O attention: broken hygroscopic agent particles do not use again.

The air will be discharged outside directly without through the hygroscopic agent, so it will prolong the service life of hygroscopic agent. The hygroscopic agent can be u- sed many times after drying. The dry hygroscopic agent is blue, when it contains water, the color begins to change, until the color turn to pink, and the hygroscopic agent should be changed. Before changing hygroscopic agent, screw off the four nuts and open the cover. The water contained hygroscopic agent can be put in the 150°C oven for drying until it turns to blue again.

Note: the broken hygroscopic agent granule can’t be used again.

1. the full name of the model code must be stated when ordering, such as air flow: HRF /min hygroscopic capacity: IKG hygroscopic air temperature scavenging device: QLS1-1-10